Click OK when prompted for a password.Click Yes when prompted to send the configuration.Network configuration will vary, and should be determined on a case by case basis. Note : The IP Address above is for example only. Enter in the IP address, Subnet Mask, and Gateway for the printer.The IP Address Setting should be on Manual.Select the printer to configure, then click Configuration.Click Ethernet on the left, then click Search.Note : If the utility is not present on the register, it can be download it from theĪdmin Portal > Help > Downloads > More downloads. Run the Printer Utility application found at: Start > Epson TMNetWinConfig.Examples of where this end can go: A wall jack, network switch, router, or firewall.Ĭomplete the following steps, for each network printer, on any one of the POS registers: Configure the Printer IP setting in the Epson TMNetWinConfig Utility.The other end of the ethernet cable should be plugged into the known working Brink network source.
The back of the printer should have ethernet and power cable firmly plugged in.Estimated reading time: 5 minutes Hardware Configuration
